793W90900 - ACRIFILLER - FONDO ACRILICO 2K WB

FIELD OF APPLICATION:

General purpose water-based industrial acrylic filler primer: machine tools, metalwork, industrial bodywork, plastics. It can be used directly on the substrate, as it offers excellent general adhesion. Good dry sandability.

PREPARATION OF THE PRODUCT:

Acrylic primer has excellent adhesion on degreased and sanded sheet metal, primers, old, well-cured and properly prepared paints. Iron and steel: SA2 grade sandblasting or perfect mechanical cleaning of the substrate by sanding with removal of rust, calamine and subsequent cleaning by degreasing with aqueous solutions or with solvents. Aluminum: Mechanical cleaning by sanding, followed by degreasing with solvents. ABS and ABS-PC: Degrease with suitable solvents.

Mix Component A thoroughly until uniform consistency and color. Then mix with Component B in the ratio given below and mix again, possibly with a stirrer or mechanical device. Comp. A: 793W90900 100 parts by weight 100 parts by volume Comp. B: CZW707 12 parts by weight 18 parts by volume Dilute with water to the desired application viscosity.

PRODUCT SPECIFICATIONS:

TYPE OF PRODUCT

Two-component;

APPEARANCE OF THE FILM

Matte.

COLORS

White

DENSITY

1,45 Kg/lt (± 0,05)

SUPPLY VISCOSITY

10” (± 2) FORD 8 at 20 °C

DRY RESIDUE

63% (± 2%)

DRYING

Dry dust-free - Print-free: 4-5 hours. 15’ at 25 °C   - Drying 30' - 40' at A.T. before baking   - Forced Drying 30’ - 40’ at 60 °C

RECOMMENDED COATS

Two coats

RECOMMENDED THICKNESS

40 - 60 µm

THEORETICAL YIELD

8,8 m2/lt or 6,4 m2/kg at 50 µm dry

POT-LIFE AT 20 °C

60’. The pot-life decreases at higher temperatures.

RECOATING:

After 40' minimum at A.T. (25 °C) and within 16 hours, or after 30' at 60 °C. After complete curing, light sanding of the film is necessary to ensure good adhesion of the top coat.

SAFETY REGULATIONS:

Water-based products must be protected from frost. Follow the instructions on the labeling and in the safety data sheet.

STORAGE CONDITIONS:

The storage room should be dry, out of sunlight, in undamaged packages and with a temperature between +5 °C and +35 °C. Rev.: 09/22 The data and information contained in this sheet are the result of our experience and accurate laboratory tests. However, since the painting process represents a set of operations that are beyond our control, they do not therefore guarantee, in any way, the final performance of the cycle.

The data and information contained in this sheet are the result of our experience and accurate tests and laboratory tests.
However, since the painting process is a set of operations that are beyond our control, they therefore do not constitute, in any way any form of guarantee on the final performance of the cycle itself.