190.R7035 - EPOFLEX INDUSTRIALE GRIGIO RAL.7035

FIELD OF APPLICATION:

Can be applied directly to: iron, aluminum, galvanized iron and light alloys, fiberglass, plastics.

RECOMMENDED FINISHES:

Epoxy – Polyurethane and Acrylic finishes

PREPARATION OF THE SUBSTRATE:

Iron surfaces: SA2 sandblasting, or thorough mechanical cleaning followed by degreasing with solvents. Hot-dip Galvanized Steel: Light sandblasting or alternatively sanding or buffing followed by degreasing with solvent Aluminum: Mechanical cleaning by sandblasting (where possible), sanding or buffing followed by degreasing with solvents. Copper and brass: Remove any traces of oxidation by sanding or buffing followed by degreasing with solvents. Thermosetting resins: Degreasing with solvents.

PREPARATION OF THE PRODUCT:

Comp. A: 190.R7035 100 parts by weight 3 parts by Volume Comp. B: CZ.105 / CZ.110 / CZ.155 20 parts by weight 1 part by Volume For large surfaces and/or cabin temperature > 30 °C, we recommend D.130 Slow thinner, which ensures excellent spreading and reabsorption Over spray. Mix to uniform consistency and color; dilute with our D.150 epoxy thinners to optimum viscosity depending on the application system and/or thickness to be achieved. Applicable with conventional spray, Airmix and Airless systems.

PRODUCT SPECIFICATIONS:

TYPE OF PRODUCT

Epoxy Primer 2K

APPEARANCE

Matt

COLOUR

Grey RAL7035

SPECIFIC WEIGHT (Comp.A)

1,64 Kg/Lt (± 0,05)

SUPPLY VISCOSITY

17” ±3 FORD 8 at 25 °C SOLID % - VOLUME (A+B) 54% (±2) SOLID % - WEIGHT (A+B) 71% (±2)

DRYING TIME AT 20 °C.

Dry dust-free Print-free: 4-5 hours. 15’ - 20’ Touch-free 5 hours   Drying 24 - 36 hours at 20 °C   Forced Drying 30’ - 40’ at 60 - 80 °C

RECOMMENDED LAYERS

1 (cross layers)

RECOMMENDED - DFT

70 - 100 µm

THEORETICAL YIELD

6,7 m2/Lt-4,7 m2/Kg at 80 µm dry

POT- LIFE AT 20 °C

6 hours.

APPLICATION INSTRUCTIONS:

View pictograms Page 1.

OVERPAINTING:

With CZ.105: minimum 6 hours maximum 36 hours. With CZ.110: minimum 3 hours maximum 24 hours. After 48 hours, light sanding of the film is recommended to ensure good adhesion of the top coat.

SAFETY REGULATIONS:

Strictly follow the instructions on the labeling and in the safety data sheet.

STORAGE CONDITIONS:

The storage room must be dry and with a temperature between +10 °C and +35 °C. Rev.: 01/24 The data and information contained in this sheet are the result of our experience and accurate laboratory tests. However, since the painting process represents a set of operations that are beyond our control, they do not therefore guarantee, in any way, the final performance of the cycle.

The data and information contained in this sheet are the result of our experience and accurate tests and laboratory tests.
However, since the painting process is a set of operations that are beyond our control, they therefore do not constitute, in any way any form of guarantee on the final performance of the cycle itself.