Protective varnish for ABS, SAN, PP substrates (after flaming and/or primer). Can also be used as a pre- and post-metallization clear coat in the cosmetics (packaging) industry.
Plastic materials: The surface to be painted must be clean and free of contaminants. In some cases, specific pre-treatments (tumbling, flaming) or the use of suitable adhesion primers are required. However, carry out preliminary tests or consult Vernici Caldart Laboratory.
Comp. A : 340015 100 parts by weight Comp. B (if needed) : 20032C 5 parts by weight Diluent : 665 80 - 100 parts by weight It is possible, in special cases to eliminate distension defects, peel, bubble formation, to replace part of the diluent with retardant 10304R. It is advisable to conduct preliminary tests to determine the right amount of retardant to use.
Single-component
Glossy
Clear
0,89 kg/lt (± 0,02)
54” (±4) at 25 °C ASTM 4
28% (±1)
Drying - Print-free: 4-5 hours. 10’ at room temperature Forced Drying 60’ at 70 °C
A cross coat
Strictly follow the instructions on the labeling and in the safety data sheet.
The storage room should be dry, not exposed to the sun and with a temperature between +10 °C and +30 °C. Once the package is opened, use within 5 days. It can react with atmospheric moisture. Rev.: 06/22 The data and information contained in this sheet are the result of our experience and accurate laboratory tests. However, since the painting process represents a set of operations that are beyond our control, they do not therefore guarantee, in any way, the final performance of the cycle.
The data and information contained in this sheet are the result of our experience and accurate tests and laboratory tests.
However, since the painting process is a set of operations that are beyond our control, they therefore do not constitute, in any way any form of guarantee on the final performance of the cycle itself.
VERNICI CALDART SRL © 2022 | P.IVA IT00759630965 | Privacy Policy | Cookies Policy | Ethical Code | Whistleblowing | Financing | SOFTWEB