Z.771 - ADDITIVO FILMOGENO PER METALLIZZATI

FIELD OF APPLICATION:

The additive added to 2K gloss converters allows a metallic tint normally achievable in a double layer (metallic base + clear coat) to be reproduced in lucido diretto. Use at a rate of 10% in the following 2K Finishes: 701.00015 2K Acrylic Clearcoat; K.211 Tecnopur extra K.711 Glossy Acrilgrip. The additive when used at low dosage (1% to 3%) only works as a spreading additive and improves product leveling.

PREPARATION OF THE SUBSTRATE:

As per the data sheet of the products chosen for the cycle.

PREPARATION OF THE PRODUCT:

Usable finishes: 701.00015 2k acrylic clearcoat, K.211 Tecnopur extra, K.711 Glossy Acrilgrip. Quantity to produce 1 kg of product. 701.00015 Z.771

MIX PASTE

CZ.711 Diluent 70% 10% 20% 40% 50% 700 gr 100 gr 200 gr 400 gr 500 gr K.211 Z.771

CZ.265 Diluent 70% 10% 20% 50% 50% 700 gr 100 gr 200 gr 500 gr 500 gr K.711 Z.771

CZ.265 Diluent 70% 10% 20% 33% 50% 700 gr 100 gr 200 gr 330 gr 500 gr The metallic finish must be applied in accordance with the instructions in the relevant data sheet of the chosen finish. The only change is in the % dilution of the resulting glaze, since the addition of the additive Z.771, leads to an increase in viscosity and the product must therefore be diluted at least 50%. NOTE: For the best aesthetic result, cover the surface to be painted with 2 to 3 coats alternated by adequate flash off. Very important is to apply the product, taking care to apply not too high thickness for each coat to avoid floating and bad orientation of the effect pigments. Additive Z.771, when added at the rate of 1-3% to 2K acrylic and polyurethane enamels of the 211, 711, 2H1 and 7H1 series, increases the spreading during application, the gloss of the film obtained after drying, and reduces the out-of-print time of the products by accelerating the drying in the first curing stage.

SAFETY REGULATIONS:

Strictly follow the instructions on the labeling and in the safety data sheet.

STORAGE CONDITIONS:

The storage room must be dry and with a temperature between +10 °C and +35 °C. Rev.: 10/22 The data and information contained in this sheet are the result of our experience and accurate laboratory test. However, since the painting process represents a set of operations that are beyond our control, they do not therefore guarantee, in any way, the final performance of the cycle.

The data and information contained in this sheet are the result of our experience and accurate tests and laboratory tests.
However, since the painting process is a set of operations that are beyond our control, they therefore do not constitute, in any way any form of guarantee on the final performance of the cycle itself.